Connections are done at the signal input section on the rear of the speaker. Use spade or banana connectors for optimum contact and ease of installation. Hand-tighten the binding posts and be careful not to over tighten.
Standard Connections (Single or Dual binding post)
For standard connection of speakers with Single or Dual input terminals, leave the jumper bars attached and connect using either set of input terminals.
Bi-Wire Connections (Dual binding post)
For bi-wire connection of speakers with two input terminals, start by removing the jumper bars attached.
Using two sets of speaker wire, connect one to each set of input terminals.
Connect the other speaker wire ends to the corresponding amp terminal.
Combine the 2 Negative ends to the Negative terminal.
Combine the 2 Positive ends to the Positive terminal.
Bi-Amp Connections (Dual binding post)
IMPORTANT! When bi-amping, always use amplifiers with identical gain.
For bi-amp connection of speakers with two input terminals, start by removing the jumper bars attached.
Using two sets of speaker wire, connect one to each set of input terminals.
Connect the other speaker wire ends to the corresponding amp terminals
Connect the 2 Negative speaker wire ends to the 2 Negative amp terminals. (one to each)
Connect the 2 Positive speaker wire ends to the 2 Positive amp terminals. (one to each)
